Configure Vlan, Ports And Security - Avaya Communication Server 1000 Installation And Commissioning Manual

Configure VLAN, Ports and Security

Table 25: Common Parameters
Set controller name.
Set controller IP address.
Set controller default route.
Configure VLAN IP address.
Configure VLAN on ports used for APs and
connected to the LAN.
Enable Power-Over-Ethernet on ports use
for APs.
Enable Telnet. Enabling Telnet is optional,
but allows configuration through the CLI
without requiring a serial cable.
Table 26: SMP Parameters
Place all SVP traffic (protocol 119) traffic in
the class-of-service (CoS) queue 7.
(Optional) If data traffic is to be shared with
voice traffic, it must be explicitly enabled.
Disable Internet Group Management
Protocol (IGMP) snooping on a designated
VLAN. IGMP snooping must be disabled
when running SpectraLink Radio Protocol
(SRP), which is used with the SpectraLink
8000 Telephony Gateway. SRP uses
multicast packets to do an SRP Check-In.
Avaya WLAN IP Telephony Installation and Commissioning
Purpose
Purpose
Command
set system name <Name>
set system ip-address <IP
Address>
set ip route default <IP
Address> <VLAN Number>
set interface <VLAN Number> ip
<IP Address> <IP Mask>
set vlan 1 port <Port Number>
set port poe <Port Number>
enable
set ip telnet server enable
Command
set security ac lip SVP permit
cos 7 119 0.0.0.0
255.255.255.255 0.0.0.0
255.255.255.255
set security acl name svp
permit 0.0.0.0
255.255.255.255 commit
security acl svp set security
acl map svp vlan 1 out set
security acl map svp vlan 1 in
set igmp disable vlan <name of
vlan>
Common Parameters
November 2010 143