Tps Cli Commands - Avaya Communication Server 1000 Installation And Commissioning Manual

Troubleshooting
LD 32 STAT command
The wireless handsets are shown REGISTERED in the standby and active modes. In the
following example, 61 0 is an IP Phone 2004 and 62 2 is a WLAN Handset 2211 in the standby
mode.
.stat 61 0
IDLE REGISTERED 00
.stat 62 2
IDLE REGISTERED 00
LD 117 Inventory command
In the inventory report, the wireless handsets have a specific release code and NT code, similar
to the IDU command output. In the following example, 61 0 is an IP Phone 2004 and 62 2 is a
WLAN Handset 2211.
=> inv prt sets
Set inventory:
17 10 2003 8 17 21, 17 10 2003 8 17 22, 6
i2004, 61 00, i2004 NT2K00GI 66 0 7641C7, I2004 , 6000
i2004, 62 02, i2004 NTTQ5010 66 7 017E47, I2211 , 6502
LD 117 STIP command
The STIP command can be used for wireless handsets; however, the wireless handset alias
IP address appears as the TERMIP in the command output, instead of physical IP address. In
the following example, the 192.168.10.200 is an alias IP address assigned by the WLAN IP
Telephony Manager 2245.
TN
______ _______________________________ ______ __________ ____________
0x600a 00000000000003000907a017e476607
CAPS
_________
0x00000000
--------------------------------
codec bdwth(k) codecCaps desc
--------------------------------
4 190
3 190
17 47
value = 537232412 = 0x2005841C
For information about more CLI commands, see

TPS CLI commands

The following sections describe TPS command line interface (CLI) commands.
182 Avaya WLAN IP Telephony Installation and Commissioning
HWID
0x00000000 1
0x00000000 1
0x00000001 1
STATUS HOSTIP TERMIP
REG 47.11.214.165 192.168.10.200 0x1450
Zones on page 85.
PORT
_______
November 2010