Continuing Configuration Through Telnet; Connecting Through Telnet - Avaya Communication Server 1000 Installation And Commissioning Manual

Figure 29: WLAN Application Gateway 2246 connection to Application Server through a modem

Continuing configuration through Telnet

After the IP address for the WLAN Application Gateway 2246 is configured, the WLAN
Application Gateway 2246 reset and connected to the LAN and the Application Server, Telnet
can be used to continue the WLAN Application Gateway 2246 configuration.

Connecting through Telnet

Connection to the WLAN Application Gateway 2246 can be done through the network using
Telnet. Telnet can only be used after the WLAN Application Gateway 2246 IP address is
configured.
The Telnet method of connection is used for routine maintenance of the system for both local
and remote administration, depending on the network.
Follow the steps in
page 199 to connect to a WLAN Application Gateway 2246 through Telnet.
Connecting to a WLAN Application Gateway 2246 through Telnet
1. Run a Telnet session to the IP address of the WLAN Application Gateway 2246.
2. Log in to the WLAN Application Gateway 2246.
When the configuration procedure is complete, the NetLink OAI System screen adds a Feature
Programming option. Also, the OAI Line Configuration option is replaced by a Telephone Line
Configuration option.
Avaya WLAN IP Telephony Installation and Commissioning
Connecting to a WLAN Application Gateway 2246 through Telnet
The NetLink OAI System screen appears.
Because the WLAN Application Gateway 2246 is initially configured, the NetLink
OAI System screen now has some different options displayed.

Continuing configuration through Telnet

November 2010
on
199