Serial Port Connection; Telnet Connection - Avaya Communication Server 1000 Installation And Commissioning Manual

is established, connection to the WLAN IP Telephony Manager 2245 can be done through the
network using Telnet.
Avaya recommends that you perform the complete initial configuration after the serial
connection is made.

Serial port connection

Follow the steps in
port on page 133 to connect to the WLAN IP Telephony Manager 2245 through a serial port.
Connecting to the WLAN IP Telephony Manager 2245 through a serial port
1. Using a DB-9 female, null-modem cable, connect the WLAN IP Telephony Manager
2. Run a terminal emulation program (such as HyperTerminal), or use a VT-100
3. Press Enter to display the login screen.
4. Enter the default login admin and the default password admin.

Telnet connection

The Telnet method of connection is used for routine maintenance of the WLAN IP Telephony
Manager 2245 for local and remote administration, depending on the network.
Important:
You can only use Telnet after you configure the WLAN IP Telephony Manager 2245 IP
address.
Avaya WLAN IP Telephony Installation and Commissioning
Connecting to the WLAN IP Telephony Manager 2245 through a serial
2245 to the serial port of a terminal or PC.
terminal with the following configuration:
• Bits per second: 9600
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
Important:
If you use Windows 2000, you must install Service Pack 2 to enable the use of
™
HyperTerminal .
The login name and password are case-sensitive.
The NetLink SVP-II System screen appears.
Connect to the WLAN IP Telephony Manager 2245
November 2010 133