Figure 23: WLAN IP Telephony Manager 2245 front panel
• RS-232 port—the male DB-9 connector (DTE). Provides an RS-232 connection to a
terminal, terminal emulator, or modem for system administration.
• Link LEDs
- LNKOK—lit when there is a network connection
- ACT—lit when there is system activity
- COL—lit if there are network collisions
• NETWORK—connects the WLAN IP Telephony Manager 2245 to the wired Ethernet LAN
• ERROR LED—lit when the system has detected an error
• Status LEDs—indicate system error messages and status
- 1—heartbeat
- 2—active calls
- 3, 4, 5—currently unused
• PWR—connects to the AC adapter supplying power to the system
Use only the provided Class II AC adapter with 24V DC, 1A output.
Wall-mount
The WLAN IP Telephony Manager 2245 can be mounted either vertically or horizontally.
Wall-mounting the WLAN IP Telephony Manager 2245
1. Use a 18-inch drill bit to drill four pilot holes, on 1.84 by 12.1 inch centers
2. Insert the #8 x 34-inch screws in the pilot holes and tighten, leaving a 18 to 14-
3. Slide the WLAN IP Telephony Manager 2245 over the screws until the WLAN IP
4. Tighten screws fully.
Avaya WLAN IP Telephony Installation and Commissioning
Warning:
(approximately equivalent to 1-1316 inch by 12-18 inch).
inch gap from the wall.
Telephony Manager 2245 drops into place in the keyhole openings of the flange.
WLAN IP Telephony Manager 2245 installation tasks
November 2010
103