Wlan Specific Configuration; Switches; Cisco Access Points And Switches - Avaya Communication Server 1000 Installation And Commissioning Manual

DSCP tags determine packet priorities for QoS. Avaya recommends the following settings:
WT (In call)—46 (default 4) WT (Standby)—40 (default 0) RTP—46 (default 4) PBX—40
(default 0) Inter-SVP2—0 (default)
Other networks may use different settings—adjust as needed to match the network.
Important:
You must configure the command mls qos trust dscp on every on every Cisco switch port,
on which a 2245 is installed; otherwise, the DSCP tagging configured on the WLAN IP
Telephony Manager 2245 is ignored.

WLAN specific configuration

The following sections provide configuration information for various switches. In this document,
WLAN Security Switch means Avaya WLAN Security Switch.

Switches

This section contains configuration information for switches.
WLAN Security Switch
The 2350, 2360, and 2380 model switches have the following requirements:
• load 4.1.14
• configure radio-profile voice dtim-interval 3
• configure radio-profile voice active-scan disable (prevents the AP from going off-
channel to scan)
• radio-profile voice WMM enabled

Cisco access points and switches

This section contains configuration information for selected Cisco access points and switches.
Cisco Aironet 1200 Series
Ensure that the software is 12.3.7(JA3). This requirement is current as of November 2006 and
is subject to change.
Avaya WLAN IP Telephony Installation and Commissioning
WLAN specific configuration
November 2010 215