Avaya Communication Server 1000 Installation And Commissioning Manual page 218

Wlan ip telephony
Hide thumbs Also See for Communication Server 1000:
Table of Contents

Advertisement

Troubleshooting WLAN IP Telephony installations
For more information, go to http://www.cisco.com.
To configure the client handoff to occur after a selected number of 802.11 data packet
excessive retries, use the config advanced client-handoff command:
config advanced client-handoff <num_of_retries>
Default: 0 excessive retries (disabled)
The command to configure the client handoff to 100 excessive retries is:
config advanced client-handoff 100
Important:
2.x code is not supported. Avaya recommends that sites upgrade to 3.2.116.21 code.
Contact Avaya GNTS Technical support to obtain this code—do not download it from the
Cisco Web site.
Specific Cisco configuration examples
Table 50: 1230 connected with 2950 and 2245 connected with 2950
the steps to configure the Cisco Aironet 1230 connected with a Cisco Catalyst 2950, and the
WLAN IP Telephony Manager 2245 connected with the Cisco Catalyst 2950.
Table 50: 1230 connected with 2950 and 2245 connected with 2950
1
class-map match-all
class_SVP_VoIP
match ip protocol 119
(protocol 119 marked
the value of cos 5)
2
Policy-map wireless-
SVP-VoIP class
class_SVP_VoIP
3
int fastethernet 0.240
encapsulation dot1Q
240 service-policy
input wireless- SVP-
VoIP
4
(for return path) dot11
priority-map avvid
218
Avaya WLAN IP Telephony Installation and Commissioning
AP: 1230
2950 connected the APs
mls qos map cos-dscp 0 8 16
40 32 46 48 56
wrr-queue bandwidth 25 25
50 0 wrr-queue cos-map 1 0 1
2 4 wrr-queue cos-map 3 3 6
7 wrr-queue cos-map 4 5
(dscp 40 and 47 by default are
marked as cos 5)
int fastethernet 026 (the port
that is connected with the AP)
switchport trunk native vlan 11
switchport trunk allowed vlan
11, 240 switchport mode trunk
mls qos trust cos
on page 218 provides
2950 connected to 2245
mls qos map cos-dscp 0 8 16
40 32 46 48 56
wrr-queue bandwidth 25 25 50
0 wrr-queue cos-map 1 0 1 2 4
wrr-queue cos-map 3 3 6 7 wrr-
queue cos-map 4 5 (dscp 40
and 47 by default are marked
as cos 5)
int fastethernet 03 (the port
that connected with 2245)
switchport access vlan xx
switchport mode access mls
qos trust cos mls qos cos 5
service-policy input trust-
voice-2245
class-map match-all voice-sig
match access-group 100
November 2010

Advertisement

Table of Contents
loading

Table of Contents