Table of Contents
Advertisement
5. Configure Avaya Communication Server
This section focuses on configuring the E1 trunks on Avaya Communication Server 1000E to
connect with Dialogic IMG 1010 Media Gateway. The NTBK50AAE5 E1 2Mbps ISDN trunk
card is installed in slot 3 of the Avaya MG1000 Media gateway. These Application Notes
assume that the telephones are installed and configured and the ISDN PRI is not being
configured for the first time, so error detection thresholds and clock synchronization control are
assumed to be in place. If not, refer to the ISDN Primary Rate Interface Document in Section 11
Reference [4] for detailed descriptions. Furthermore these Applications Notes used the Co-
ordinated Dial Plan (CDP) feature to route calls from the Avaya Communication Server 1000E
over the E1 to Dialogic IMG 1010 Media Gateway. The CDP feature is assumed to be already
enabled on Avaya Communication Server 1000E, and therefore will not be described in detail.
The procedures below describe the details of configuring Avaya Communication Server 1000E:
Log in to the Unified Communications Management GUI
Launch Element Manager
Verify Equipped Feature Packages
Administer E1 card
Administer D-Channel
Administer Routes and Trunks
Administer Route List Block
Administer Distant Steering Code
Enable E1 card
Enable D-channel automatic establishment.
5.1. Login to Unified Communication Management GUI.
In these application notes, access was made via Avaya Aura System Manager using Single Sign
On. Open an instance of a web browser and connect to the web GUI for Avaya Aura System
Manager and login in with appropriate credentials.
BD; Reviewed:
SPOC 02/26/2013
Solution & Interoperability Test Lab Application Notes
©2013 Avaya Inc. All Rights Reserved.
12 of 103
DLG1010MXSM62CS
Advertisement
Table of Contents
