Avaya Communication Server 1000 Installation And Commissioning Manual page 29

related icons will stay on. For more information about how to handle error messages that occur
during initialization, see
Table 3: Avaya 6120/6140 WLAN Handset startup sequence
123 56789
123 5678
123 567
123 56
123 5
123
12
1
Ext. XXXXX
Avaya WLAN IP Telephony Installation and Commissioning
WLAN Handset 2210/2211/2212 and Avaya 6120/6140 WLAN Handset
Handset error messages
Icon The icons shown in bold turn off when one of the
The Wireless telephone has located, authenticated, and
associated with an AP, and is proceeding to higher-layer
networking functions.
4 is not used for the UNIStim protocol
6 is not used when QoS is set to WiFi Standard
The Wireless telephone is either configured for Static IP, or if
configured for DHCP, the DHCP discovery process has
started.
If DHCP is configured, a DHCP response si received that
contains a good DNS server configuration.
Used for SVP QoS only and not present when using WiFi
Standard QoS.
Indicates one of the following possibilities:
• Static IP configuration
• WLAN IP Telephony Manager 2245 address found in
DHCP option 151 response
• WLAN IP Telephony Manager 2245 address found
through DNS lookup
All networking functions are complete (notably, DHCP) and
the Wireless Telephone is proceeding with establishing the
SRP link to either the Gateway or WLAN IP Telephony
Manager 2245.
The UNIStim application has started.
At least one IP address for a PBX (DHCP Option 128) is
identified.
The Wireless Telephone successfully registers with the
PBX.
Initialization is complete. The Wireless Telephone is in
standby mode ready to receive and place calls.
on page 233.
following occurs:
Note:
Note:
November 2010 29