Traceroute - D-Link DES-7200 Cli Reference Manual

Hide thumbs Also See for DES-7200:

Table of Contents

Chapter 5 Network Connectivity Test Tool Configuration Commands

traceroute

Execute the traceroute command to show all gateways passed by the test packets from the

source address to the destination address.

The ping command can be used in the ordinary user mode and the

privileged mode. In the ordinary mode, only the basic functions of

ping are available. In the privileged mode, in addition to the basic

functions, the extension functions of the ping are also available. For

the ordinary functions of ping, five packets of 100Byte in length are

sent to the specified IP address within the specified period (2s by

default). If response is received, ‗!' is displayed. If no response is

received, ‗.' displayed, and the statistics is displayed at the end. For

the extension functions of ping, the number, quantity and timeout time

of the packets to be sent can be specified, and the statistics is also

displayed in the end. To use the domain name function, configure the

domain name server firstly. For the concrete configuration, refer to

the DNS Configuration section.

The example below shows the ordinary ping.

DES-7210# ping 192.168.5.1

Sending 5, 100-byte ICMP Echoes to 192.168.5.1, timeout

is 2 seconds:

< press Ctrl+C to break >

Success rate is 100 percent (5/5), round-trip min/avg/max

The example below shows the extension ping.

DES-7210# ping 192.168.5.197 length 1500 ntimes 100

Sending 100, 1000-byte ICMP Echoes to 192.168.5.197,

timeout is 3 seconds, data ffff source 192.168.4.10:

< press Ctrl+C to break >

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Success rate is 100 percent (100/100), round-trip

min/avg/max = 2/2/3 ms

The command is supported by all equipments.

DES-7200 CLI Reference Guide