Arp Retry Interval; Arp Retry Times - D-Link DES-7200 Cli Reference Manual

Chapter 21 IP Address Configuration Commands
21.2.2

arp retry interval

Use this command to set the frequency for sending the arp request message locally, namely,
the time interval between two continuous ARP requests sent for resolving one IP address.
The no form of this command is used to restore the default value, that is, retry an ARP
request per second.
arp retry interval seconds
no arp retry interval
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
21.2.3

arp retry times

Use this command to set the local retry times of the ARP request message, namely, the
times of sending the ARP request message to resolve one IP address. The no form of this
command can be used to restore the default 5 times of the ARP retry requests.
21-6
Parameter Description
Time for retrying the ARP request message in
the range of 1 to 3600 seconds, 1 second by
seconds
default.
The retry interval of the ARP request is 1s.
Global configuration mode.
The switch sends the ARP request message frequently, and thus
causing problems like network busy. In this case, you can set the
retry interval of the ARP request message longer. In general, it should
not exceed the aging time of the dynamic ARP entry.
The following configuration sets the retry interval of the ARP request
as 30s.
arp retry interval 30
Command
arp retry times number
DES-7200 CLI Reference Guide
Function
Set the retry time of the ARP request
message.