Lacp Port-Priority - D-Link DES-7200 Cli Reference Manual

Chapter 8 LACP Configuration Commands
Command
mode
Usage
guidelines
Examples
Related
commands
8.1.2

lacp port-priority

Use this command to set the LACP port priority. Use the no form of this command to return
to the default value.
lacp port-priority port-priority
no lacp port-priority
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
8-2
Interface configuration mode.
N/A
DES-7210(config)# interface gigabitethernet 1/1
DES-7210(config-if)# port-group 1 mode active
Command
lacp port-priority
Parameter Description
The port priority, in the range of
port-priority
0-65535.
By default, the port priority is
Interface configuration mode.
When multiple ports are to be aggregated, the ports with high
priorities take precedence and the port with the highest priority is
selected as the master port. The port priority sequence is determined
according to the wire quality.
DES-7210(config)# interface gigabitethernet 1/1
DES-7210(config-if)# lacp port-priority
DES-7200 CLI Reference Guide
Description
Set the LACP port priority.
32768.