Ipv6 Ospf Area - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
37.1.9

ipv6 ospf area

Use this command to enable the interface to participate in the OSPFv3 routing process. Use
the no form of this command to disable this function.
ipv6 ospf process-id area area-id [instance instance-id]
no ipv6 ospf process-id area [instance instance-id]
Parameter
description
Parameter Description
Default metric for the routes to be redistributed.
metric-value Its range is 1 to 16777214, and the default value
is 20.
20.
OSPFv3 configuration mode.
This command can be used with redistribute together to set the
default metric for the routes to be redistributed. But this command
does not appliy to two types of routes:
1. The default route generated with default-information originate;
2. The redistributed direct route, which always uses 20 as the
default metric value.
The following example sets the default metric for the routes to be
redistributed to 10.
default-metric 10
Command Description
Redistribute the routes.
redistribute
show ipv6 ospf Show the OSPFv3 routing process information.
Parameter Description
process-id OSPF process ID.
OSPFv3 area in which the interface participates
area area-id in.
It can be an integer or an IPv6 prefix.
Chapter 37 OSPFv3 Configuration Commands
37-9