Ip Pim Rp-Candidate - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Command
mode
Usage
guideline
Examples
Related
commands

40.1.19 ip pim rp-candidate

ip pim rp-candidate interface-type interface-number [priority priority-value] [interval
interval-seconds] [group-list access_list]
Global configuration mode
This system supports the configuration of multicast static RP, as well
as the configuration of static RP and BSR mechanisms at the same
time. When you use this command, note that:

If both the BSR mechanism and the static RP configuration take
effect, the dynamic configuration takes precedence.

You can configure multiple multicast groups (using ACL) or all
multicast groups (not using ACL) for the static RP. But a static
RP can be configured only once.

If there are more than one static RP in a multicast group, the one
of the highest IP address is used.

Only the addresses permitted by ACL are valid multicast groups.
By default, all the multicast groups 224/4 are permitted.

After configuration is performed, the static RP's source IP
address is inserted to the group range-based static RP group
tree structure. Each group range-based static multicast group
maintains the chain list structure of a static RP group. This chain
list is sorted in descending order of IP address. When you select
a RP from a static RP group, the first entry, namely the one wit
the largest IP address, will be selected first.

Deleting a static IP address also deletes this address from all the
existing static RP groups and selects one from in the existing RP
group tree structure as the RP address.
DES-7210# configure terminal
DES-7210(config)# ip pim rp-address 210.34.0.55
DES-7210(config)# ip pim rp-address 210.34.0.55 4
DES-7210(config)# access-list 4 permit 255.1.1.1 0.0.0.255
Command
access-list
Chapter 40 PIM-SM Configuraiton Commands
Description
40-13