Ip Pim Register-Rate-Limit; Ip Pim Register-Rp-Reachability - D-Link DES-7200 Cli Reference Manual

Hide thumbs Also See for DES-7200:

Table of Contents

Chapter 40 PIM-SM Configuraiton Commands

40.1.14 ip pim register-rate-limit

ip pim register-rate-limit rate

ip pim register-rp-reachability

Interface configuration mode

Upon updating the interval to send the Hello message, the time of

holding the Hello message is updated by the following principle: The

hold time is updated to be 3.5 times the transmission interval. If the

transmission interval*3.5 is more than 65535, the hold time is

updated to 65535.

DES-7210# configure terminal

DES-7210(config)# interface g 0/3

DES-7210(config)# ip pim query-interval 123

Maximum number of register packets that

can be sent per second, in the range of 1

By default, there is no rate limitation on register messages.

Global configuration mode

This command is used to configure speed of transmitting register

packet in each (S, G) status, not the speed of transmitting register

packets in the system. Using this command will decrease the load of

source DR and RP. The register packets can be transmitted at the

speed within the limit.

DES-7210# configure terminal

DES-7210(config)# ip pim register-rate-limit 3000

DES-7200 CLI Reference Guide