Ip Ospf Authentication - D-Link DES-7200 Cli Reference Manual

Chapter 32 OSPFv2 Configuration Commands
Command
mode
Usage
guidelines
Examples
Related
commands

32.1.19 ip ospf authentication

Use this command to configure the authentication type. Use the no form of the command to
restore it to the default type.
ip ospf authentication [message-digest | null]
no ip ospf authentication
Parameter
description
Default
Command
mode
32-22
Routing process configuration mode.
The snmp-server enable traps ospf command must be configured
before configuring this command, for this command is limited by the
snmp-server command.
This command is not limited by the binding of process and MIB,
allowing to enable the TRAP switch for different processes
simultaneously.
The example below enables all TRAP switches of the OSPFv2
process 100:
DES-7210(config)# router ospf 100
DES-7210(config-router)# enable traps
Command Description
Show the OSPF global configuration
show ip ospf
information.
enable
Bind the OSPFv2 process with MIB.
mib-binding
Parameter Description
message-digest Enable MD5 authentication on the interface.
null Enable no authentication.
No authentication mode is configured on the interface by
default. Here, the authentication type of the local area
applies on the interface.
Interface configuration mode.
DES-7200 CLI Reference Guide