Show Related Commands - D-Link DES-7200 Cli Reference Manual

Chapter 38 IGMP Configuration Commands

38.2 Show Related Commands

38.2.1 show ip igmp groups
Use this command to show the groups directly connected to the device and the group
information learnt from IGMP.
Command
syntax
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
38-16
show ip igmp groups [group-address | interface-type
interface-number] [detail]
Parameter Description
32-bit multicast group IP address, namely
group-address Category D address. 8 bits are in one group in
decimal form. Groups are separated with dots.
interface-type Interface type.
interface-number Interface number.
detail Show the detailed information.
N/A Show the information about all the groups.
N/A
User mode or privileged mode.
Use this command without any parameters to show group address,
interface type, and information about all the multicast groups directly
connected to the interface. Information about a specific group is
displayed if a group address is added to the command.
The following example shows information about all the groups:
DES-7210# show ip igmp groups
IGMP Connected Group Membership
Group Address Interface Uptime
224.0.1.1 eth2
224.0.1.24 eth2
224.0.1.40 eth2
224.0.1.60 eth2
239.255.255.250 eth2
239.255.255.254 eth2
DES-7200 CLI Reference Guide
Expires
00:00:09 00:04:17
00:00:06 00:04:14
00:00:09 00:04:15
00:00:05 00:04:15
00:00:12 00:04:15
00:00:08 00:04:13
Last Reporter
10.10.0.82
10.10.0.84
10.10.0.91
10.10.0.7
10.10.0.228
10.10.0.84