DES-7200 CLI Reference Guide
Examples
38.1.10 ip igmp query-interval
Use this command to configure the query interval of an ordinary member. Use the no form
to set the query interval of ordinary member to the default value.
Command
syntax
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
38.1.11 ip igmp query-max-response-time
Use this command to configure the maximum response interval. The no form of this
command to set the maximum response interval to the default value.
Command
syntax
Parameter
description
The following example sets the limitation to 300:
DES-7210(config-if)# ip igmp limit 300
ip igmp query-interval seconds
no ip igmp query-interval
Parameter
Description
Query interval of ordinary member, in second.
seconds
The range is 1 to 18000s.
125 seconds.
Interface configuration mode.
The time to query an ordinary member can be changed by configuring
the query interval of the ordinary member.
Configure the query interval of ordinary member to 120s on the
interface Ethernet 0.
DES-7210(config-if)# ip igmp query-interval 120
Configure the query interval of ordinary member to the default value
on the interface Ethernet 0.
DES-7210(config-if)# no ip igmp query-interval
ip igmp query-max-response-time seconds
no ip igmp query-max-response-time
Parameter
Description
seconds
The maximum response interval, in second. The
Chapter 38 IGMP Configuration Commands
38-9