Show Related Command; Show Storm-Control; Show Port-Security - D-Link DES-7200 Cli Reference Manual

Chapter 43 Port-based Flow Control Configuration Commands
Usage
guidline
Examples
Related
commands

43.2 Show Related Command

The following commands are used to show the security configuration of the port:

show storm-control

show port-security

43.2.1 show storm-control
Use this command to show storm suppression information.
show storm-control [interface-id]
Parameter
description
Default
configuration
Command
mode
43-8
Arp-check have three modes: auto, disabled and enabled. In the auto
mode, only if the port is address-binding can it check ARP packet. In the
disabled mode, it does not check ARP packet. In the enabled mode, it
checks ARP packet regardless of whether the port is address-bingding or
not.
DES-7210(config-if)# arp-check
Command
show port-security
Parameter
interface-id
All information is displayed.
Privileged mode.
DES-7200 CLI Reference Guide
Description
Show the port security configuration
Description
Interface on which
suppression is enabled
the storm