Layer 3 Feature; Traceroute - D-Link DGS-3312SR Release 3.5 Manual

Layer 3 Feature

The Switch's Layer 3 monitoring windows are described below.

Traceroute

The following window will aid the user in back tracing the route taken by a packet before arriving at the Switch. When
initiated, the Traceroute program will display the IP addresses of the previous hops a packet takes from the Target IP
Address entered in the window, until it reaches the Switch.
To trace the route of a packet, set the following parameters located in this window, and click Start.
Parameter
Target IP Address
TTL
Port
Timeout
Probe
DGS-3312SR Stackable Gigabit Layer 3 Switch
Figure 8- 25. Traceroute window
Description
Enter the IP address of the computer to be traced.
The time to live value of the trace route request. This is the maximum number of
routers the traceroute command will cross while seeking the network path between
two devices.
The virtual port number. The port number must be above 1024.The value range is
from 30000 to 64900.
Defines the time-out period while waiting for a response from the remote device.
The user may choose an entry between 1 and 65535 seconds.
The probe value is the number of times the Switch will send probe packets to the
next hop on the intended traceroute path. The default is 1.
225