Duplex - D-Link DES-7200 Cli Reference Manual

Chapter 6 Interface Configuration Commands
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
6.1.10

duplex

Use the duplex command in the interface configuration mode to specify the duplex mode
for the interface. Use the no form of the command to restore it to the default setting.
duplex {auto | full | half}
no duplex
Parameter
description
Default
configuration
Command
mode
6-8
Auto.
Interface configuration mode.
If an interface is the member of an aggregate port, the rate of the
interface depends on the rate of the aggregate port. You can set the
rate of the interface, but it does not take effect until the interface exits
the aggregate port. Use show interfaces to display configuration.
The rate varies by interface types. For example, you cannot set the
rate of a SFP interface to 10M or 100M.
DES-7210(config)# interface gigabitethernet 1/1
DES-7210(config-if)# speed 100
Command Description
Show the interface information.
show interfaces
Parameter Description
auto Self-adaptive full duplex and half duplex
full Full duplex
half Half duplex
Auto.
Interface configuration mode.
DES-7200 CLI Reference Guide