Show Ipv6 Ospf Virtual-Links - D-Link DES-7200 Cli Reference Manual

Chapter 37 OSPFv3 Configuration Commands
Examples
Related
commands
37.2.7

show ipv6 ospf virtual-links

Use this command to show the virtual link information of the OSPFv3 process.
show ipv6 ospf [process- id] virtual-links
Parameter
description
Command
mode
Examples
37-32
The following command shows the topology of each area of OSPFv3.
DES-7210# show ipv6 ospf topology
OSPFv3 Process (1)
OSPFv3 paths to Area (0.0.0.0) routers
Router ID Bits Metric
Interface
1.1.1.1 EB --
2.2.2.2 E
FastEthernet 1/0
OSPFv3 paths to Area (0.0.0.1) routers
Router ID Bits Metric
Interface
1.1.1.1 B
Command Description
ipv6 router ospf Start the OSPFv3 routing process.
area range Configure the address range of the OSPF area.
Parameter Description
process- id OSPFv3 process number, 1.65535
Privileged mode.
The following command shows the information about the OSPFv3
virtual link.
DES-7210# show ipv6 ospf virtual-links
Virtual Link VLINK1 to router 2.2.2.2 is down
Transit area 0.0.0.1 via interface FastEthernet 1/0, instance ID
0
Local address *
Remote address 3333::1/128
Transmit Delay is 1 sec, State Down,
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit
5
Hello due in inactive
Adjacency state Down
DES-7200 CLI Reference Guide
Next-Hop
1 2.2.2.2
Next-Hop
--