Chapter 44 802.1X Configuration Commands
Usage
guidelines
Examples
Related
commands
44.5.10 dot1x port-control auto
In the interface configuration mode, use this command to allow the port to participate in
authentication. Use the no form of the command to restore it to the default value.
dot1x port-control auto
no dot1x port-control
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
44-22
You can use show dot1x private-supplicant-only to check the
802.1x setting.
Example
This example configures to use the private supplicant only:
DES-7210# configure t
DES-7210(config)# dot1x private-supplicant-only
DES-7210(config)# end
DES-7210#
Command
show
private-supplicant-only
N/A.
By default, the port does not participate in 802.1x authentication.
Interface configuration mode.
Use the show dot1x command to show the 802.1X configuration.
The following example sets the port to participate in authentication:
DES-7210# configure terminal
DES-7210(config)# interface g0/1
DES-7210(config-if)# dot1x port-control auto
DES-7210(config-if)# end
DES-7200 CLI Reference Guide
Function
Show the information about the
dot1x
private supplicant.