Maximum Routes - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
commands
42.2.9

maximum routes

Use this command to limit the maximum routes within the vrf. Use the no form of this
command to cancel this limit.
maximum routes limit {
no maximum routes
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
ip vrf
show ip vrf
warn-threshold
Parameter
limit
warn-threshold
warning-only
There is no limit for the configuration by default.
VRF configuration mode
This command is used to limit the allowed routes within the VRF. If it
only hopes to get the warning, use the warning-only parameter.
Chapter 42 MPLS Configuration Commands
Create a VRF instance
Show the VRF configurations
| warning-only }
Description
Limit the routes. The routes which exceed the
limits will not be written into the core route
table, ranging from 1 to 4294967295.
Print the warning threshold, It will print the
warning after the percent is reached,
ranging from 1 to 100.
After the configured limit is reached, it only
prints the warning. But it is still allowed to
add to the core route table.
42-49