Mpls Ldp Hello-Holdtime - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands

42.1.16 mpls ldp hello-holdtime

Use this command to configure the holdtime in seconds for LDP hello packets on each
interface. Use the no form of this command to restore the default value.
[no] mpls ldp hello-hellotime <
Parameter
description
Default
configuration
Use the downstream active distribution mode.
Interface configuration mode.
If the interconnected LDP sessions use different distribution modes,
the du mode will be used forcibly for both of them. Use this command
to reset and rebuild the LDP session.
DES-7210(config)# interface vlan 10
DES-7210(config-if)# mpls ldp distribution-mode dod
Command
loop detection-mode
1-65535
Parameter
<1-65535>
15 seconds
Chapter 42 MPLS Configuration Commands
Description
Configure loop detection
>
Description
Holdtime of hello messages, in seconds.
Holdtime 65535 stands for the hello messages
will never timeout.
42-15