Spanning-Tree Reset; Spanning-Tree Tx-Hold-Count - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide

18.1.11 spanning-tree reset

Use this command to restore the spanning-tree configuration to the default value. This
command does not have the no form.
spanning-tree reset
Parameter
description
Command
mode
Examples
Related
commands

18.1.12 spanning-tree tx-hold-count

Use this command to configure the TxHoldCount of the STP in the global configuraiton
mode, the maximum number of the BPDU messages sent in one second. Use the no form
of the command to restore it to the default setting.
spanning-tree tx-hold-count tx-hold-count
no spanning-tree tx-hold-count
Parameter
description
Default
configuration
Command
mode
Examples
N/A.
Global configuration mode.
DES-7210(config)# spanning-tree reset
Command
show spanning-tree
show spanning-tree
interface
Parameter
tx-hold-coun
t
The default value is 3.
Global configuration mode.
DES-7210(config)# spanning-tree tx-hold-count 5
Chapter 18 MSTP Configuration Commands
Description
Show the global STP configuration.
Show the STP configuration of the
interface.
Description
Maximum number
messages sent in one second in the range
1 to 10.
of the BPDU
18-11