Traceroute - D-Link DGS-6600-48TS Manual

DGS-6604 m

traceroute

traceroute [OPTIONS] {IP-ADDRESS | IPV6-ADDRESS}
Syntax Description
OPTIONS
IP-ADDRESS
IPV6-ADDRESS
CLI Reference Guide
To display a hop-by-hop path through an IP network from the switch to a specific
destination host, use the traceroute command.
(Optional) the option can be any combination of the following parameters:
-w WAIT_TIME
Optionally used to specify the amount of time (in seconds) that traceroute will
wait for an ICMP response message. The allowed range for WAIT_TIME is from
1 to 300 seconds.
-i INITIAL_TTL
Optional setting that causes traceroute to send ICMP datagrams with a TTL
value equal to INITIAL_TTL instead of the default TTL of 1. This option causes
traceroute to skip processing for hosts that are less than INITIAL_TTL hops
away.
-m MAX_TTL
Optional setting used to specify the maximum TTL value for outgoing ICMP
datagrams. The allowed range for MAX_TTL is from 1 to 255.
-p DEST_PORT
Optionally used to specify the base UDP destination port number used in
traceroute datagrams. This value is incrementally altered each time a datagram
is sent. The allowed range for DEST_PORT is from 1 to 65535. Use this option
in the unlikely event that the destination host is listening to a port in the default
traceroute port range.
-q NQUERIES
Optionally used to specify the number of datagrams to send for each TTL value.
The allowed range for NQUERIES is from 1 to 1000.
-s PACKET_SIZE
Optionally used to specify the number of bytes in addition to the default of 40
bytes, of the outgoing datagrams. The allowed range is from 0 to 1420.
-t TOS
Optionally used to specify the ToS to be set in the IP header of the outgoing
datagrams. The allowed range for TOS is from 0 to 255.
IP address in dot notation (a.b.c.d) of the destination host.
IPv6 address of the destination host.
traceroute
906