Bpdu Src-Mac-Check - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Parameter
description
Default
configuration
Command
mode
Examples
Related
commands

18.1.26 bpdu src-mac-check

Use this command to enable the BPDU source MAC address check function on the
interface. Use the no form of this command to disable the function.
bpdu src-mac-check H.H.H
no bpdu src-mac-check
Parameter
description
Default
configuration
Command
mode
Examples
The disabled parameter is used to disable Autoedge on the
interface.
Enabled.
Interface configuration mode.
DES-7210(config)# interface gigabitethernet 1/1
DES-7210(config-if)# spanning-tree autoedge disabled
Command
show spanning-tree
interface
Parameter Description
Indicate
H.H.H messages from this MAC address are
received.
Indicate that the BPDU messages
no
from any MAC address are received.
Disabled.
Interface configuration mode.
DES-7210(config)# interface gigabitethernet 1/1
DES-7210(config-if)# bpdu src-mac-check 00d0.f800.1e2f
Chapter 18 MSTP Configuration Commands
Function
Show the STP
information of the interface.
that only the
configuration
BPDU
18-19