Bgp Confederation Identifier - D-Link DES-7200 Cli Reference Manual

Chapter 33 BGP4 Configuration Commands
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
Platform
description

33.1.14 bgp confederation identifier

Use this command to configure the AS confederation identifier. Use the no form of the
command to restore it to the default setting.
bgp confederation identifier as-number
no bgp confederation identifier
Parameter
description
Default
33-12
N/A.
BGP configuration mode.
In general, one group is only configured with one route reflector. In
this case, the Device ID of the route reflector can be used to identify
this cluster. To increase the redundancy, you can set more than one
route reflector within this cluster. In this case, you must configure the
cluster ID, so that one route reflector can identify the route update
from other route reflectors of this cluster.
DES-7210(config)# router bgp 65000
DES-7210(config-router)# bgp cluster-id 10.0.0.1
Command
bgp client-to-client
reflection
neighbor
route-reflector-client
Parameter
as-number
N/A.
DES-7200 CLI Reference Guide
(must be entered in form of IP address).
Description
Configure the route reflection between
clients.
Configure the client of the route reflector and
configure itself as the route reflector.
Description
AS confederation identifier in the range of 1
to 65535