DES-7200 CLI Reference Guide
32
32.1 Configuration Related Commands
32.1.1
area
Use this command to configure the specified OSPF area. The no form of this command
removes the specified OSPF area.
area area-id
no area area-id
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
OSPFv2
Commands
Parameter
Description
Number
area-id
authentication is enabled, a decimal
integer or an IP address
No OSPF area is configured by default.
Routing process configuration mode.
Use the no form of this command to remove the specified OSPF area
and its configuration, including the removal of the area-based
configuration commands of area authentication、area default-cost、
area filter-list、area nssa, ect.
Users can not remove the OSPF configuration under the following
conditions:
It fails to remove all configurations for the backbone area with the
virtual link configured. Now the virtual link configuration must be
removed before removing the backbone area.
Chapter 32 OSPFv2 Configuration Commands
Configuration
of
the
area
where
32-1