Ip Igmp Snooping Query-Max-Response-Time - D-Link DES-7200 Cli Reference Manual

Chapter 16 IGMP Snooping Configuration Commands
ip igmp snooping max-groups number
no ip igmp snooping max-groups
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
Related
commands

16.1.12 ip igmp snooping query-max-response-time

This command specifies the time for the switch to wait for the member join message after
receiving the query message. If the switch does not receive the member join message
within the specified time, it considers that the member has left and then deletes the
member.
ip igmp snooping query-max-response-time time
no ip igmp snooping query-max-resposne-time
Parameter
description
16-10
Parameter Description
number The parameter ranges 0 to 4294967294.
N/A.
Interface configuration mode.
If a maximum number of multicast groups are configured, the device
will no longer receive and process IGMP Report messages when the
number of multicast groups on this interface is beyond the range.
The following example shows how to configure the maximum number
of multicast groups to 100 on the megabit interface 0/1:
DES-7210(config)# interface fastEthernet 0/1
DES-7210(config-if)# ip igmp snooping max-group 100
Command Description
ip igmp Filter multicast groups that pass through
snooping filter a port.
Parameter
time
DES-7200 CLI Reference Guide
Description
The aging time of the routing inerface that
the switch learns dynamically.