Ip Igmp Query-Max-Response-Time - D-Link DGS-6600-48TS Manual

DGS-6604

ip igmp query-max-response-time

ip igmp query-max-response-time SECONDS
Syntax Description
SECONDS
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface vlan1000
Switch(config-if)# ip igmp query-max-response-time 10
Switch(config-if)# end
CLI Reference Guide
Use this command to configure the maximum response time advertised in IGMP
queries.
Set the maximum response time, in seconds, advertised in IGMP queries.The
range is 1 to 25.
10 seconds
VLAN interface configuration
This command controls the period during which the group member can respond
to an IGMP query message before the router deletes the membership.
This command applies to interfaces configured for both IGMP Layer-3 multicast
protocols and IGMP Snooping (L2 mode and the interface function as a querier).
The group membership interval is equal to query-interval* robustness + max
response time.
This example shows how to configure IGMP max query response time to 10
seconds on VLAN 1000.
Verify the settings by entering the show ip igmp interface command.
ip igmp query-max-response-time
270