Memory Unit Type G 256Mb / I 512Mb (Only For M020) - Ricoh SH-P1 M020 Field Service Manual

Controller Options
2
5. Tighten the two screws to secure the Gigabit Ethernet board.
• Check the Gigabit Ethernet board is connected firmly to the interface board slot.
6. Attach the ferrite core [3] to the LAN cable, and connect the LAN cable to the machine.
7. Make sure that the machine can recognize this option (see 'p.40' at the end of this section).

Memory Unit Type G 256MB / I 512MB (Only for M020)

• Unplug the main machine power cord before you do the following procedure.
1. Controller unit ( p.96)
2. Place the controller board on a flat surface. The SDRAM module is installed in the slot shown in the
illustration above.
35