Ricoh SH-P1 M020 Field Service Manual page 29

• Do not set ON (Lock) the write-protect switch of the system SD card or application SD card on the
machine. If the write-protect switch is ON, a download error (e.g. Error Code 44) occurs during a
firmware upgrade or application merge.
1. Turn the main switch off.
2. Make sure that an SD card is in SD Card Slot 1 (Upper). The application program is copied to this
SD card.
3. Insert the SD card with the application program in SD Card Slot 2 (Lower).The application
program is copied from this SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5873-001 "Move Exec."
7. Follow the messages shown on the operation panel.
8. Turn the main switch off.
9. Remove the SD card from SD Card Slot 2 (Lower).
10. Turn the main switch on.
11. Check that the application programs run normally.
Undo Exec
"Undo Exec" (SP5873-002) lets you copy back application programs from an SD card to the original
SD card. You can use this program when, for example, you have mistakenly copied some programs by
using Move Exec (SP5873-001).
• Do not set ON (Lock) the write protect switch of the system SD card or application SD card on the
machine. If the write protect switch is ON, a download error (e.g. Error Code 44) occurs during a
firmware upgrade or application merge.
1. Turn the main switch off.
2. Insert the original SD card in SD Card Slot 2 (Lower). The application program is copied back into
this card.
3. Insert the SD card with the application program in SD Card Slot 1 (Upper).The application
program is copied back from this SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5873-002 "Undo Exec."
7. Follow the messages shown on the operation panel.
Controller Options
2
27