Ricoh SH-P1 M020 Field Service Manual page 215

7931 019 Toner End Date
7931 020 Conductor Time1
7931 021 Conductor Time2
7931 022 Conductor Time3
7931 023 Conductor Time4
AIO Info: Log
Displays information about the AIO log.
• Returns a value of "0" if the number stored in the cartridge is not recognized.
7941
• This is information on the AIO ID Chip so if the AIO was not installed, if the AIO
was not set properly, or if the front door was open, no value would be logged
because the machine could not communicate with the AIO.
7941 001 Log1: Serial No.
7941 002 Log1: Refill Flag
Displays Year-Month-Date when toner end occurred.
Default: 8
Displays a number in the range "0" to "99999999",
this is the count for OPC.
[ 0 to 99999999 / 0 / 1]
• This information resides at four locations (020,
021, 022, 023. The recycle count determines
where the value is written.
• The counter increments by "1" for every 6 sec. of
drum rotation time.
• To calculate the actual time in sec., multiply the
displayed value by 6.
Displays an ASCII string in the Log1, that identifies the
manufacturer
Default: 16
• This data is originally entered as BCD and
changes into a 16-character string in order to
convert it to ASCII.
• However, only 10 bytes can be used to
communicate with the controller, so the 16 bytes
are truncated to 10 bytes.
Displays "RF" when the cartridge requires refilling
Cartridge version number in the Log1
Default: 2
Engine Service Mode
5
213