Ricoh SH-P1 M020 Field Service Manual page 27

4. Carefully push in the SD card (notched corner downward and leading), until it clicks into place.
Insert the SD card in the appropriate slot as follows:
• Upper slot: SD font card, NetWare card, Security SD card (Standard for M020), IPDS card.
• Lower slot: For service only (Firmware update, application move, etc.)
The SD card supplied with the optional hard disk (M020 model only) can be used in either of the
two slots.
5. Reattach the cover over the SD card. Fasten the screw to secure the cover.
• Do not touch the card while the printer is in use. It may come loose, even if pushed only slightly. The
slot cover must be reattached.
• You can confirm that the SD card was installed correctly by checking the control panel menu.
Depending on the SD card, certain menu items appear on the display.
• SD card supplied with the optional hard disk (M020 model only): Make sure [Machine Data
Encryption] appears in [Security Options]. Depending on settings, [Machine Data Encryption]
might not appear. For details about how to confirm this setting, consult your administrator.
• NetWare card: Make sure [NetWare] appears in [Effective Protocol] under [Network].
Controller Options
2
25