Ricoh SH-P1 M020 Field Service Manual page 138

5. System Maintenance Reference
bit 2
bit 3
bit 4
5
bit 5
bit 6
bit 7
1003 [Clear Setting]
Initialize System
1003 001
Initializes settings in the "System" menu of the user mode.
1003 003 Delete Program
1004 [Print Summary]
Service Summary
1004 001
Prints the service summary sheet (a summary of all the controller settings).
136
Job Cancel
If this bit switch is enabled, all jobs will be cancelled after a jam occurs.
Note: If this bitsw is enabled, printing under the following conditions might result in
problems:
- Job submission via USB or Parallel Port
- Spool printing (WIM >Configuration > Device Settings > System)
DFU
Timing of the PJL Status ReadBack (JOB END)
when printing multiple collated copies.
This bitsw determines the timing of the PJL USTATUS JOB END sent when multiple
collated copies are being printed.
0 (default): JOB END is sent by the device to the client after the first copy has
completed printing. This causes the page counter to be incremented after the first
copy and then again at the end of the job.
1: JOB END is sent by the device to the client after the last copy has finished printing.
This causes the page counter to be incremented at the end of each job.
DFU
DFU
DFU
Disabled
Enabled
(Not
(Cancelled)
cancelled)
- -
Disabled Enabled
- -
- -
- -