Ricoh SH-P1 M020 Field Service Manual page 181

5828 069 JobSpooling(Protocl)
5828 090 TELNET(0:OFF 1:0...
5828 091 Web(0:OFF 1:ON)
5828 145 Active IPv6 Link Local
5828 147 Active IPv6 Stat 1
5828 149 Active IPv6 Stat 2
5828 151 Active IPv6 Stat 3
5828 153 Active IPv6 Stat 4
5828 155 Active IPv6 Stat 5
This SP determines whether job spooling is enabled or
disabled for each protocol. This is an 8-bit setting.
Bit 0: LPR
Bit 1: FTP (Not Used)
Bit 2: IPP
Bit 3: SMB
Bit 4: BMLinks (Japan Only)
Bit 5: DIPRINT
Bit 6: Reserved (Not Used)
Bit 7: Reserved (Not Used)
Default: 01111111b (7f H)
Disables or enables Telnet operation. If this SP is
disabled, the Telnet port is closed.
[0 to 1 / 1 / -]
0: OFF
1: ON
Disables or enables the Web operation.
[0to1 / 1 / -]
0: OFF
1: ON
This is the IPv6 local address referenced on the
Ethernet or wireless LAN (802.11) in the format:
"Link-Local address" + "Prefix Length"
The IPv6 address consists of a total 128 bits
configured in 8 blocks of 16 bits each. These notations
can be abbreviated. See "Note: IPV6 Addresses "
below this table.
These SPs are the IPv6 stateless addresses (1 to 5)
referenced on the Ethernet or wireless LAN (802.11)
in the format:
"Stateless Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits
configured in 8 blocks of 16 bits each.
Engine Service Mode
5
179