Ricoh SH-P1 M020 Field Service Manual page 179

Error Caused by Response
from GW URL
5816 209 Instl Clear
5816 250 Print Com Log
5821 NRS Address
5821 002 RCG IP Address
5824 NVRAM Upload
5824 001 NVRAM Upload
Attempted dial up overseas without the
-2385 correct international prefix for the
telephone number.
-2387 Not supported at the Service Center
-2389 Database out of service
-2390 Program out of service
-2391 Two registrations for same device
-2392 Parameter error
-2393 External RCG not managed
-2394 Device not managed
-2395 Box ID for External RCG is illegal
-2396 Device ID for External RCG is illegal
-2397 Incorrect ID2 format
-2398 Incorrect request number format
Releases the machine from its embedded RCG setup.
Prints the communication log.
Sets the IP address of the RCG (Remote
Communication Gate) destination for call processing
at the remote service center.
[00000000h to FFFFFFFFh / 00000000h / -]
Uploads the UP and SP mode data (except for
counters and the serial number) from NVRAM on the
control board to a flash memory card.
While using this SP mode, always keep the front cover
open. This prevents a software module accessing the
NVRAM during the upload.
Engine Service Mode
5
177