Ricoh SH-P1 M020 Field Service Manual page 147

1159 001 SC Detection
1902 OHP Clutch Rotate
1902 001 OHP Clutch Rotate
1953 Switch FAN Ctrl. DFU
1953 001 Main FAN
SP2-xxx: Drum
2001 Charge Voltage DFU
2001 001 Charge Voltage
2103 Erase Mag Adjust
2103 001 Lead Edge Width
2103 002 Trail. Edge Width
2103 003 Left
2103 004 Right
2112 Main-scan Mag.
Disables or enables the consecutive jam error for the
fusing unit.
[0 to 1 / 0 / 1]
When set to "1" (on), this SC code is issued after the
3rd consecutive jam in the fusing unit.
OHP Clutch Rotations
Selects the number of rotations for the bypass feed
roller when the paper type is set for "Transparencies".
Change this setting to "2" if jams occur frequently
when feeding transparencies from the bypass tray.
[1 to 2 / 1 / 1]
1 = 1 rotation, 2 = 2 rotations
RTB 26
-
SP1953 defined in more detail
[0 to 1 / 1 / 1]
Charge Roller Bias setting
Adjusts the voltage applied to the charge roller for
printing.
[1000 to 2000 / 1550 /1 V]
Adjust the erase margin by deleting image data at the
margins.
[0 to 9.9 / 2.0 / 0.1 mm/ step]
[0 to 9.9 / 4.0 / 0.1 mm/ step]
[0 to 9.9 / 2.0 / 0.1 mm/ step]
[0 to 9.9 / 2.0 / 0.1 mm/ step]
Main Scan Magnification
Engine Service Mode
5
145