6. Tighten the two screws by turning them clockwise with a coin, and then secure the hard disk board
by tightening the third screw from the under side of the controller board.
7. Align the controller board with the top and bottom rails, and then push it carefully in, until it stops.
8. Fasten the controller board to the printer with the two screws.
• After finishing installation, you can check whether the hard disk is properly installed: Print the
configuration page from the [List/Test Print] menu. If it is installed properly, you will see "Hard Disk"
will appear for "Device Connection" on the configuration page.
• If the Hard disk is not properly installed, repeat this procedure.
• For details on printing the configuration, see "p.40" at the end of this section.
Controller Options
2
39