Table of Contents
Advertisement
6. Troubleshooting
6
Streaks in the Sub Scan Direction
If you see streaks or lines at a regular interval in the sub scan direction:
1. Measure the width of the interval between the streaks.
2. Identify the component in the table below that is causing the problem (based on the size of the
measured interval), then inspect that component.
Interval Width (approx.)
117.8 mm
280
96 mm
OPC Drum (diameter 30.5 mm)
50 mm
Transfer Roller (diameter 16 mm)
Fusing Roller (diameter 37.5 mm)
113 mm
Pressure Roller(diameter 36 mm)
Check:
Advertisement
Chapters
Table of Contents
