Ricoh SH-P1 M020 Field Service Manual page 273

1st/2nd Message
@Remote Cert. update failed
Cannot connect=>Comm.Serv. Check
proxy user/password.
Cannot connect with DHCP server.
(101/201)
Cannot connect with NetWare print
server. (107/207)
Cannot print
Check network settings.(103/203)
Classification Code Error
Connect failed: WirelessCard Turn
power off, check card.
Cover Open. Please close the
indicated cover.
Duplex mode is in off position for (tray
name)
Problem/Solution
Updating the @Remote certificate failed.
• Retry updating the @Remote certification.
The proxy user name or password is incorrect.
• Check the proxy server settings, and change the user
name and/or password if they are incorrect.
Cannot obtain IP address from DHCP server.
• Consult your network administrator.
Connection with NetWare print server is unavailable.
• Consult your network administrator.
Cannot print
• Check the file you want to print is a supported file type.
Check for misfeeds and ask your network administrator
for help.
The IP address setting is incorrect.
• Check the IP address, subnet mask, and gateway
address.
• Consult your network administrator.
A classification code is not specified for the print job.
• Enter a classification code using the printer properties
and print the document again.
Wireless LAN card trouble
• Confirm that there is a Wireless LAN board installed.
Check that it is a supported board. If it is, check it is
installed correctly. Install the correct board properly
Cover is open.
• Close the cover indicated on the control panel.
The duplex mode for the indicated tray is off; you can only
use one-sided printing.
• Press [Change] to change the tray's settings, press
[JobReset] to reset the job, or press [Form Feed] to force
printing.
Error Messages
6
271