Ricoh SH-P1 M020 Field Service Manual page 31

2. Fully insert the Wireless LAN interface board.
3. Tighten the two screws to secure the interface board.
• Check the Wireless LAN interface board is connected firmly to the interface board slot.
• You may have to move the machine if the reception is not clear.
• Make sure that the machine is not located near an appliance or any type of equipment that
generates strong magnetic fields.
• Put the machine as close as possible to the access point.
UP Mode Settings for Wireless LAN
Enter the UP mode. Then do the procedure below to perform the initial interface settings for IEEE 802.11
a/g. These settings take effect every time the machine is powered on.
• You cannot use the wireless LAN if you use Ethernet.
1. Press the "User Tools/Counter" key.
2. On the touch panel, press "System Settings".
Controller Options
2
29