Ricoh SH-P1 M020 Field Service Manual page 232

5. System Maintenance Reference
3. Remove the SD card cover [A] (
4. Insert the SD card into Slot 2 [D] (Lower).
5. Turn on the power. The screen remains blank for about 20 to 30 sec., "Please Wait" appears, then
you will see "Engine", the first item available for selection.
• The first selection "Engine" will appear about 1 min. after switching the power on.
6. Scroll to the program to upgrade, then press [#Enter].
7. Press the [Online] to start the upgrade. You will see a series of messages. If you selected "Engine",
for example", you would see:
ROM Update
*****************
5
Updating
*****************
Updated
Power Off On
The "Power Off On" message appears after about 90 sec.
8. Turn off the power, remove the SD card from Slot 2 [D] (Lower), and turn on the power.
-or-
If you intend to update another program, leave the SD card in Slot 2 [D] (Lower) and turn on the
power.
• The firmware has not updated successfully if the "Power Off On" message does not appear. If
this occurs, turn the machine power off/on and repeat the procedure.
230
[B] x 1).