4. Tighten the two screws to secure the interface board.
• Confirm that the IEEE 1284 interface board was correctly installed by printing the configuration
page. If it is correctly installed, "Parallel Interface" will appear for "Device Connection" on the
configuration page.
• If the board was not installed properly, repeat the procedure from step 3.
• For details on printing the configuration, see "p.40" at the end of this section.
Gigabit Ethernet
• Unplug the main machine power cord before you do the following procedure.
1: Gigabit Ethernet Board
2: Protective caps (one each for the Ethernet port and the USB port)
3: Ferrite core (Design of the ferrite core varies according to printer model.)
1. Check the contents of the package.
Controller Options
2
33