Attaching Memory Unit Type C 256Mb (Sdram Module) - Ricoh AP610N - Aficio B/W Laser Printer Setup Manual

Installing Options
Attaching Memory Unit Type C 256MB
(SDRAM Module)
R CAUTION:
• Do not touch the inside of the
controller board compartment.
Doing so may cause a malfunc-
tion or a burn.
3
Important
❒ Before touching the memory unit,
touch something metal to discharge
any static electricity. Static electrici-
ty can damage the memory unit.
❒ Do not subject the memory unit to
physical shocks.
❒ If a printer hard disk is already in-
stalled, temporarily remove it and
insert the memory unit. Reinstall
the printer hard disk after insert-
ing the memory unit.
❒ Before using the new memory
unit, you must make settings in the
printer driver.
A
Turn off the power of the printer,
and then unplug the printer's pow-
er cable and the interface cable.
B
If the duplex unit is attached,
push down the lever on right side
( ) and pull out the duplex unit
until it stops ( ).
If the duplex unit is not attached,
go to the following steps.
36
C
Remove the two screws holding
the controller board in place.
Note
❒ Use a coin or similar object if the
screws do not turn easily.
❒ The removed screws are re-
quired in fastening the control-
ler board.
D
Pull out the handle of the control-
ler board.
ZKGX320E
ZKGX280E
ZKGX370E