Ricoh SH-P1 M020 Field Service Manual page 233

NVRAM Data Upload/Download
Uploading NVRAM Data
Follow this procedure to upload the NVRAM data to an SD card.
• If the NVRAM data cannot be uploaded successfully before NVRAM replacement, you must
manually input the required settings after the NVRAM has been replaced. For this reason, you
should always print an SMC report before NVRAM replacement.
1. Enter the SP mode and do SP5990 1 (All) to print the SMC Report.
2. Exit the SP mode.
3. Turn off the main power switch.
4. Remove the SD card slot cover [A] (
5. Insert an SD card into Slot 2 [D] (Lower).
6. Turn on the main power switch.
7. Enter the SP mode and do SP5824 (NVRAM Upload).
8. Push [#Enter].
<NVRAM Upload>
execute?
9. Push [#Enter].
10. You will see "Processing". Then when you see "result=OK" the NVRAM data has been uploaded
successfully.
This procedure creates an NVRAM folder on the SD card with one file that holds the NVRAM data.
The file name is the serial number and the file extension is *.nv.
x 1 [B]).
NVRAM Data Upload/Download
5
231