5. System Maintenance Reference
Engine Service Mode
Engine Mode Table
Notation
[range/default/step]
DFU
SP1-xxx: Feed
5
Lead Edge Reg.
Adjusts the printing leading edge registration for feeding from the trays and duplex
1001
tray using the trimming area pattern (SP5-902-003 No.14).
Push [
The specification is 4±2 mm
138
Example: [-9 to +9 / +3.0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, value reset to +3.0 after an NVRAM reset,
and the value can be changed in 0.1 mm steps with each key press.
Denotes "Design or Factory Use". Do not change this value.
Leading Edge Registration
] or [
] to select the settings (plus or minus).
What it means