Route-Map - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related
match interface
Commands
match ip address
match ip next-hop
match ip route-source
routers.
match metric
match route-type

route-map

Enable a route map statement and configure its action and sequence number. This command also places you
in ROUTE-MAP mode.
C9000 Series
Syntax
route-map map-name [permit | deny] [sequence-number]
To delete a route map, use the no route-map map-name [permit | deny]
[sequence-number] command.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match the next-hop interface.
— redistributes routes that match an IP address.
— redistributes routes that match the next-hop IP address.
— redistributes routes that match routes advertised by other
— redistributes routes that match a specific metric.
— redistributes routes that match a route type.
Access Control Lists (ACL) 373